How to re-calibrate the t-bar on the SE-2800 & HS-2800?
Nov 03 2020
|
SE-2800 & HS-2800
Q: How do I re-calibrate the t-bar on my SE/HS-2800?
A: Please follow the following steps –
- Move the T-Bar to its lowest position.
- Power OFF the SE/HS-2800 switcher
- Press and hold down button 1 on both the Program and Preset rows of the switcher’s keyboard
- Power ON the SE/HS-2800 switcher while still holding down the buttons in step 3.
- The switcher will start but the keyboard lights will remain dead except for the T-Bar progress LEDs. When these LEDs flash ON and OFF release the buttons from step 3.
- Move the T-Bar to its highest position and then press the CUT button.
- Move the T-Bar back to its lowest position and then press the AUTO TAKE button.
- To exit the calibration procedure press the CLOCK button.
- Ensure the TIMER button is OFF.
- Test the T-Bar.
These instructions can also be found on page 38 of a product manual.
