NVS-40

NVS-40 Factory Reset Instructions

NVS-40 Factory Reset Instructions

NVS-40 Factory Reset Instructions

Oct 05 2021 | NVS-40

How to restore the Factory Default IP Address on the NVS-40:

  1. Power off your NVS-40
  2. Disconnect the Network cable from your NVS-40 Encoder
  3. Press and hold the MODE, RECORD and STREAM buttons on the front panel of the NVS-40.  Keep the buttons pressed and power on the NVS-40.IMG_2729.jpg
  4. Keep holding the buttons until you see the NVS-40's power light go out, then release the buttons. (It takes about 20 seconds)
  5. Power the unit off again
  6. Connect the Network cable to the NVS-40
  7. Power on the Encoder and it should be reset to factory.
  8. You should be able to open a web browser and enter 192.168.1.200 to access the login page of your NVS-40.  If you cannot locate the device, please try our Device Finder Utility if you are using a PC, Link: Device Finder.  Mac users can utilize LanScan from the App Store:  LanScan

The NVS-40 will be restored to factory default IP address of: 192.168.1.200

Note: This function is only supported for firmware versions 1.4.3 or later.

СОПУТСТВУЮЩИЕ ТОВАРЫ

Ответы на часто задаваемые вопросы о продукте
ДОПОЛНИТЕЛЬНЫЙ
NVS-40

WHAT CAN WE HELP YOU WITH??

Datavideo support is here to help.